The CNC machining workflow typically includes the following steps: First, based on the part drawings and machining requirements, a machining program is written; then, the program is input into the computer control system; next, the system interprets the program and controls the machine tool to perform machining operations; finally, the machined part is inspected and evaluated to ensure that it meets the design requirements.
The CNC machining workflow
Popular Products
Butt Splice Connector
At the bench, wire joints hold. In year three, the machine fails after a few thousand thermal cycles loosen the
C Washers
A C washer is a flat washer with an opening in the outer ring, allowing it to be installed sideways without removing
Triangular Recess Head Screws
Triangular recess head screws carry a true triangular socket in the head — three straight walls meeting at three
Copper Lug: Barrel Design
A heavy cable ends its working life at a stud. Everything the conductor has to survive - engine-bay heat, inverter
Two-Hole Head Screws
Most drive systems rely on a recess formed into the fastener head, but the two-hole drive uses the opposite concept —
Pin Terminal: End-Form Selection
Every screwed connection starts with the same question: what sits between the bare conductor and the screw. Strip a